7.2.
Disassembly of the Power nozzle
■The Power nozzle is specialized for MC-BJ870 (direct current). Do not replace it with a component from another model.
7.2.1.
Brush cover
1. Turn over the Power nozzle and move the
"UNLOCK" position using a flathead screwdriver or simi-
lar tool.
2. Open the Partition complete and remover the Brush cover
from the Floor nozzle lower unit.
7.2.2.
1. Lift up the Agitator assembly and remove the belt, then
mark to the
remove the Agitator assembly.
7.2.3.
1. Remove the securing screws from the bottom of the
Power nozzle (4 screws including 1 special screw).
44
Agitator assembly
Floor nozzle upper assy