Panasonic MC-BJ870-S149 Service Manual page 45

■Special screw
The screws used to attach the Floor nozzle lower unit
include one special screw as shown in the diagram
below.
Use a Torx screwdriver to remove the special screw.
2. Turn the Power nozzle upright again and remove the
Floor nozzle upper assy.
*It can be easily removed by wrapping a piece of cloth
around a flathead screwdriver, inserting it into the space
between the Partition complete and Floor nozzle upper
assy, and slowly and carefully prying them apart.
7.2.4. Lever unit
1. Remove the Lever unit in the direction of the arrow.
7.2.5. Floor nozzle pad right
1. Insert a flathead screwdriver into the place indicated with
the arrows on the diagram and remove the Floor nozzle
pad right from the Floor nozzle lower unit.
■Caution
• When removing the Floor nozzle pad right, be careful
that the Spring D within does not spring out and become
lost. If the Spring D falls out of place, place it back as
shown in the diagram.
• Be careful not to mix up Spring B and Spring D when set-
ting the springs. If left and right are mixed up, it will not
function properly.
45