Mounting Holes - Omron HL-5030 Manual

Mounting
To mount the Limit Switch securely, be sure to use two M5 Allenhead
bolts and washers.
The tightening torque applied to each bolt is 4.90 to 5.88 N·m. To
mount the Limit Switch more securely, use two M5 screw holes on the
rear panel and rear holes for positioning if the model is the HL-
5@@@G-Series Limit Switches.

Mounting holes

Two, 5.2-dia. holes (located
diagonally for securing the rear side)
Two, M5 screws or 5.2-dia. holes (located
diagonally for securing the front side)
Only the HL-5@@@G has M5 x 0.8 screw holes on the rear side.
Using the Switches
Actuator Position Change
(HL-5000, HL-5030, HL-5050)
To change the angle of the actuator, loosen the Allen-head bolt on the
side of the actuator lever. Then the actuator can be set at any angle.
Loosen the
Allenhead
bold
http://www.ia.omron.com/
± 0.15
50
± 0.15
24
Others
• Do not use the Limit Switch outdoors, otherwise the Limit Switch will
become damaged by rust or ozone.
• The Limit Switch is not suitable in places exposed to the spray of
rainwater, seawater, or oily water. Consult your OMRON
representative for models resisting rainwater, seawater, and oily
water.
• If high-sealing performance is required along with shielded wiring or
conduit wiring, use the D4C or WL.
Head Direction Change
(HL-5000, HL-5030, HL-5050, HL5200)
To change the head direction, loosen the two mounting screws. Then
the head can be changed at 90° increments in one of four directions.
HL-5000
Head mounting
HL-5030
screw (Small white
screw that can be
turned with either
a Phillips-head or
flat-blade screw-
driver)
Head mounting screw
(Black non-removable
torque screw)
HL-5050
The head of the HL-5200 can be mounted in two directions only.
(Refer to the following illustration.)
HL-5200
Head mounting screw (white)
Head mounting screw (white)
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
HL-5000
Head mounting screw
(Black non-removable
torque screw)
Head mounting screw
(Small white screw that
can be turned with either
a Phillips head or
flat-blade screwdriver)
5