Shop fox W1875 Owner's Manual page 56

Table/Dado.Insert.
Adjustment
The table/dado insert must sit perfectly flush with the
table to provide a smooth, continuous surface for the
workpiece to slide over. The insert is held in place by
a magnet and sits on top of four adjustment screws
(see Figure 71).
The insert should be checked and adjusted any time it is
removed and replaced, after prolonged use, or any time
you notice the workpiece or fence does not slide smoothly
over the insert.
Tools.Needed.
Hex Wrench 4mm ...............................................1
Straightedge .....................................................1
To.check.and.adjust.table.insert,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Place straightedge across insert and make sure insert
is flush with table at front and back of throat.
— If insert is flush with table, no adjustments are
necessary.
— If insert is not flush with table, proceed to Step 3.
3. Insert hex wrench through holes shown in Figure 71.
Loosen screws to raise insert, or tighten screws to
lower it.
4. Repeat Steps 2–3 until insert is perfectly flush with
surface of table.
Note: Table insert should be firmly installed (should
not rock) in the table. Each screw should support
insert evenly.
Model W1875 (For Machines Mfd. Since 1/20)
Qty
Figure 71. Location of table/dado insert
holes with adjustment screws.
-54-