Fence Scale Calibration - Shop fox W1875 Owner's Manual

Model W1875 (For Machines Mfd. Since 1/20)
Fence.Scale.Calibration
The fence scale indicator window, shown in Figure.70,
can be calibrated with the fence scale if you notice that
your cuts do not accurately match what is shown on the
fence scale.
Tools.Needed.
Phillips Head Screwdriver #2 ..................................1
Scrap Wood (14" Min. Length) ................................1
Tape Measure ....................................................1
To. calibrate. fence. scale. indicator. windows,. do. these.
steps:
1. Position and lock fence at 13", as indicated by scale,
then cut your scrap piece of wood.
2. Reposition and lock fence at 12", as indicated by
scale.
3. Flip your scrap piece of wood over, placing side that
was cut in Step.2 against fence, and cut your scrap
piece of wood.
4. Measure width of freshly cut workpiece with tape
measure. Workpiece width should be exactly 12". If
it is not, then adjust indicator window to match the
width of workpiece.
Qty
Figure.70. Fence indicator window.
-53-
Indicator Window
Screw