Specification - Pentair BIG BLUE20 Manual

Specification

 Item Number: 150233
 Model: 1" #20 Big Blue, HFPP w/PR*
 Max. Dimension: 19 x 59 cm (7.45" x 23.22")
 Flow Rate: 55.5 lpm (15 gpm)
 Max. Temperature: 37.7 °C (100°F)
 Max. Pressure: 6.2 bar (90 psi)
* Tested and Certified by NSF International
Precaution
Warning: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection
before or after the system.
Caution: Filter must be protected against freezing, which
can cause cracking of the filter and water leakage.
Caution: The rubber O-ring provides the water tight seal
between the cap and the bottom of housing.
It is important that the O-ring be properly seated in the
groove above the threads of the housing or a water leak
could occur.
Caution: Because of the product's limited service life and
to prevent costly repairs or possible water damage, we
strongly recommend that the bottom of all plastic housings
be replaced every ten years. If the bottom of your housing
has been in use for longer than this period, it should be
replaced immediately. Date the bottom of any new or
replacement housing to indicate the next recommended
replacement date.
Notes:
 For cold water use only.
 The contaminants or other substances removed or
reduced by this water treatment device are not
necessarily in your water. Ask your local water
municipality for the water analysis or have your
water tested by a lab.
 Do not install where system will be exposed to
direct sunlight.
 Filter cartridge life varies depending on filter type,
usage, and water conditions.
 The replacement filter cartridge used with this
system has a limited service life. Changes in taste,
odor, or flow of the water being filtered indicate
that the cartridge should be replaced.
 Use only PENTAIR replacement cartridges.