Controlspace Cc-64 Control Center - Bose ControlSpace ESP-88 Service Manual

DISASSEMBLY PROCEDURES
ControlSpace ® CC-64 Control Center
Refer to Figure 6 for the following proce-
dures.
1. Front Panel Removal
1.1 Grasp the edge of the front panel (2) and
pull it away from the rest of the unit. The
snaps should release and the front panel
should come off easily.
2. EMC Shield Removal
2.1 Place the unit face down onto a soft
surface.
2.2 Using a Phillips-head screwdriver,
remove the four screws (11) that secure the
EMC shield (1).
2.3 Lift off the EMC shield.
3. Main PCB Removal
3.1 Pull off the five control knobs (3) from
the front of the unit.
3.2 Perform procedure 2.
3.3 Unsolder the ribbon cable connections
located at the left side of the main PCB (8)
near the RJ-45 connector.
3.4 Remove the four screws (11) that secure
the Main PCB.
3.5 Slide the Main PCB off of the posts and
lift it off.
4. LED PCB Removal
4.1 Perform procedure 3.
4.2 Remove the five screws (11) that secure
the LED PCB (7) to the front panel (9).
4.3 Slide the PCB off of the posts and lift it
off.
5. LCM Display Module Removal
5.1 Perform procedure 3, but do not
unsolder the ribbon cable connection to the
Main PCB (8). You can swing the Main PCB
out of the way to allow access to the LCM
display module (6) screws.
5.2 Remove the four screws (10) that secure
the LCM display module in place.
5.3 Lift off the LCM display module. Take
care to not lose the four nylon washers (12)
on the screws or the four nylon spacers
under the LCM display module.
67