Reversing The Direction The Door Opens - Brandt ULN2510 Instruction Manual

Reversing the direction the door opens

The doors normally open to the left (hinges on the right); if you wish to open the door to the right,
you can modify the direction in which it opens by following the instructions below. To ensure correct
installation, please scrupulously follow the directions and the sequence of operations below:
1. Gently tilt the appliance backwards.
2. Remove the plinth by pulling the lugs A on the
lower part towards you and swivelling the
plinth upwards to disengage it (Drawing R1).
Remove cover B from its housing on the left
and insert it in the housing on the right
(Drawing R2).
3. Remove the bottom hinge pin and release it
from its housing C; retrieve the plastic
distance piece placed between the door and
the hinge on the pin; unscrew the bottom
hinge D and screw the pin into the left-hand
hole in the hinge (Drawing R3).
4. Remove the door from the appliance (Drawing
R3).
5. ** Unscrew the metal spacer Y (Drawing R3)
located on the bottom right-hand side.
6. ** Turn the spacer Y over (Drawing R3) and screw
it onto the bottom left-hand side.
(** Points 5 and 6 apply only to certain models)
7. Remove the spacer and the pin E from the top
hinge and remove it from its housing on the
tight-hand side (Drawing R4).
8. Turn the pin E over 180° and insert it into the
right-hand opening on the top hinge (Drawing
R4).
9. Insert the appliance's door into the top hinge
on the left-hand side (Drawing R4).
10. Insert the bottom hinge D in the door, ensur-
ing that the plastic spacers are correctly insert-
ed over the pins.
11. Screw the bottom hinge D in place.
12. Re-attach the plinth and return the appliance
to a vertical position.
Wait two hours before restarting your
appliance.
D
31
Drawing R1
A
A
A
A
Drawing R2
B
Drawing R3
D
C
Dessin R4
Drawing R4
E
E
EN
Y