Ongoing Maintenance Of Your Appliance; Cleaning Your Appliance; Changing The Light Bulb - Brandt ULN2510 Instruction Manual

Ongoing maintenance of your appliance

Disconnect your appliance prior to performing any maintenance operation. Grasp
the plug directly, instead of pulling on the power cable.

Cleaning your appliance

We recommend that you clean and
disinfect your appliance regularly
for improved hygiene and to keep
your food completely safe.
Remove all the food from the freezer. Place it
in isothermic bags or wrap it in newspaper and
store it in a cool place.
Clean your appliance inside and out with a bi-
carbonate of soda solution (1 dessertspoon of
bicarbonate to 4 litres of water). Do not use al-
cohol, scouring powder or detergents, which
could damage the surfaces.
Do not use a high-pressure steam
cleaner. The very hot steam could
damage the surfaces and the elec-
trical circuits; you would expose
yourself to a risk of electrocution.
Rinse with water, dry with a cloth.
Don't forget to clean the condenser from time
to time: this is at the back of the appliance
(see the section on "Description of your appli-
ance"). Use a dry paintbrush to do this or, bet-
ter yet, your vacuum cleaner.
Reconnect your appliance, and adjust the
temperature if necessary, as shown in the
section on "Adjusting your freezer's tempera-
ture ", and press the "Quick Freeze" button.
Wait 3 or 4 hours before placing the food back
in your appliance.
After 24 hours, release the "Quick Freeze"
button to stop this operation.

Changing the light bulb

Disconnect your appliance
Your appliance may be fitted with a light under
the control panel.
Proceed as follows to change the bulb:
- Remove the protective grill using a pointed
tool (a flat screwdriver or a knife) by levering
on the tab (Fig. R1).
- You can then see the bulb. You must
unscrew it to replace it with a new one (Fig.
R2). Then re-insert the protective grill by fol-
lowing the above instructions in reverse order.
44
drawing R1
drawing R2
EN