INSTALLATION
Remove transport bolts
Warning!
!
• You must remove the transport bolts from the backside before using the product.
Loosen the 4
transport bolts with
a spanner.
Levelling the washer dryer
Warning!
!
• The lock nuts on all four feet must be screwed tightly against the housing.
Connect the water supply hose
Warning!
!
To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush or modify water inlet hose.
Note!
• Connect manually, do not use tools. Check if the connections are tight.
Remove the bolts
including the rubber
parts and keep them
for future use.
1. Loosen the lock nut.
2. Turn the foot until it reaches the floor.
3. Adjust the legs and lock the nuts with
a spanner. Make sure the machine is
level and steady.
Connect the water supply
hose to the water inlet
valve and a water tap with
cold water as indicated.
11
Close the holes
using the cover
caps.