Disconnecting The Pc2 Keyboard; Connecting The Keyboard - Kurzweil PC2 Series Service Manual

Disconnecting the PC2 Keyboard

Follow this procedure if you are merely replacing one or more keys.
1. Refer to Figure 4-11.
2. Tilt the PC2 up and remove the four keyboard rear screws, then lay the PC2 flat on your
work surface.
3. Move the PC2 forward so that the front hangs over the edge of your work surface, giving
you access to the remaining screws.
4. Remove the four keyboard front screws.
Caution: The keyboard Aftertouch flex cable from the keyboard is connected to the Mod
Wheel Assembly and is secured to the bottom enclosure with reinforced tape. When
following the instructions below, be certain that you only slightly lift or move the
Keyboard Assembly to avoid damage to the flex cable.
5. The 16 screws that secure the keyboard to the wooden spacer rest in holes provided for
them on the bottom enclosure. To move the keyboard, lift the keyboard up slightly to free
the 16 screws from their positions on the bottom enclosure.
6. Lift the keyboard up and move it approximately one inch to the right (as viewed standing
at the keyboard).
7. You can now move the keyboard back approximately one inch toward the rear so that you
can remove keys for replacement. See page 4-22 for the procedure to remove and replace
keys.

Connecting the Keyboard

1. Position the keyboard so that the 16 screws that secure the wooden spacer to the keyboard
are resting in the holes provided for them on the bottom enclosure.
Caution: Be certain that the Aftertouch flex cable is correctly positioned and that the
nylon reinforced tape securing it to the bottom enclosure is still properly applied.
2. Refer to Figure 4-11.
3. Move the PC2 forward so that the front hangs over the edge of your work surface, and
install the four keyboard front screws.
4. Slide the PC2 back onto your work surface.
5. Tilt the PC2 up and install the four keyboard rear screws.
PC2/PC2X Disassembly/Assembly
PC2 Keyboard Assembly
4-21