Removing The Enclosure Support Walls; Left Enclosure Support Wall; Right Enclosure Support Wall; Replacing The Enclosure Support Walls - Kurzweil PC2 Series Service Manual

PC2/PC2X Disassembly/Assembly
Top Enclosure

Removing the Enclosure Support Walls

Left Enclosure Support Wall

1. Remove the four screws that secure the left enclosure support wall to the top enclosure,

Right Enclosure Support Wall

1. Remove the six screws that secure the right enclosure support wall to the top enclosure,

Replacing the Enclosure Support Walls

Left Enclosure Support Wall
1. Align the center screw holes of the three-hole groupings in the left enclosure support wall
2. Install the four screws that secure the left enclosure support wall to the top enclosure.
Right Enclosure Support Wall
1. Align the center screw holes of the three-hole groupings in the right enclosure support
2. Install the six screws that secure the right enclosure support wall to the top enclosure.

Removing the Connector Board

1. Follow the procedure described on page 4-8 to remove the right enclosure support wall.
2. Following Steps 3–5, disconnect the cables listed in Table 4-2.
3. Disconnect the stranded wire cable from J301 on the Connector Board.
4-8
and remove the left enclosure support wall.
and remove the right enclosure support wall.
with the thread marks in the extrusion.
wall with the thread marks in the extrusion.
Ref. Name
J301 PC2 Power
J302 Audio
J303 MIDI/CPU
J304 Front Panel
J305 Slider
J306 Treble
J307 Bass
J308 Wheels
Table 4-2 Connector Board cables
Cable Type
stranded wire Engine Board
flat ribbon Engine Board
flat ribbon Engine Board
flat ribbon Front Panel Board
flat ribbon Slider Board
flat ribbon Keyboard Assembly
flat ribbon Keyboard Assembly
flat ribbon Mod Wheel Assembly
Destination