Opening The Pc2/Pc2X; Pc2 Bottom - Kurzweil PC2 Series Service Manual

PC2/PC2X Disassembly/Assembly

Opening the PC2/PC2X

Opening the PC2/PC2X

PC2 Bottom

Refer to Figure 4-1. Arrows indicate the locations of the enclosure support wall, endcap and rear
panel screws.
Keyboard
*
Rear panel
*Endcap locking bracket screws
1. Tilt the PC2 up and remove the eight enclosure support wall screws.
2. Place the unit flat on your work surface.
3. Move the unit so that the rear panel portion of the unit hangs over the edge of your work
4. Slide the unit back onto the work surface.
4-2
Enclosure support wall screws
Access panel
Figure 4-1 PC2 bottom enclosure
Caution: Do not remove the endcap or rear panel screws at this point of the procedure.
surface. This gives you access to the seven screws that secure the rear panel portion of the
top enclosure to the bottom enclosure. Remove the seven screws.
Note: Two of the rear panel screws also secure the rear panel portion of the access panel.
It is not necessary to remove the five remaining access panel screws.
Rear panel screws
*