Front Panel Assembly; Removing The Front Panel Assembly; Replacing The Front Panel Assembly - Kurzweil PC2 Series Service Manual

PC2R Disassembly/Assembly

Front Panel Assembly

Front Panel Assembly
The Front Panel Assembly consists of the front panel faceplate, a mounting bracket for the front
panel boards, and four printed circuit boards. The boards mounted on the Front Panel Assembly
are the Right Front Panel, LCD, Left Front Panel, and Headphone/Volume/Power Switch.

Removing the Front Panel Assembly

Refer to Figure 3-4. The bottom edge of the Front Panel Assembly and front edge of the bottom
enclosure connect to form a lip.
Figure 3-4
1. Tilt up the front edge of the PC2R.
2. Using a #1 screwdriver, remove the four screws that secure the Front Panel Assembly to
3. Slide the Front Panel Assembly forward and away from the bottom enclosure.

Replacing the Front Panel Assembly

1. Position the Front Panel Assembly so that its bottom edge is under the front edge of the
2. Tilt up the front edge of the PC2R and install the four black flat head machine screws.
3-8
Lip
Front Panel Assembly and bottom enclosure
the bottom enclosure.
Note: Before continuing, be sure that you have a soft surface to rest the Front Panel
Assembly on so that the front panel switches, jacks, and rotary potentiometers are not
damaged.
Caution: There are four cables connected to the Front Panel Assembly. You do not need to
disconnect these cables.
bottom enclosure.