Table of Contents
Advertisement
Troubleshooting
Problem
Inaccurate
temperature or
humidity
No rainfall
Inaccurate wind
readings
Display screen
not working
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
• Make sure both the display unit and 5-in-1 sensor are
placed away from any heat sources or vents
(see page 7).
• Make sure both units are positioned away from
moisture sources (see page 7).
• Make sure 5-in-1 sensor is mounted at least 5 ft off of
the ground.
• Calibrate indoor and outdoor temperature and
humidity (see page 11).
• Check to ensure the rain gauge stabilizer (plastic tab)
has been removed from the bottom of the sensor.
• Clear debris, such as leaves, out of the rain collector
funnel and debris screen.
• Calibrate the Rain Gauge (see page 11).
• Verify the sensor's internal tipping lever is moving
freely by dripping a little water through the rain
collector. You should hear the lever tipping. If you do
not hear it, you may need to clean inside the sensor.
Video available at www.acurite.com/5in1
• What is wind reading being compared to? Pro
weather stations are typically mounted at 30 ft high
or more. Make sure to compare data using a sensor
positioned at the same mounting height.
• C heck location of the sensor. Ensure it's mounted a
minimum of 5 ft in the air with no obstructions around
it (within several feet).
• Ensure wind cups are spinning freely. If they hesitate
or stop try lubricating with graphite powder or spray
lubricant.
• Check that the batteries are installed correctly.
Batteries may need to be replaced.
• Reset the display by pressing and holding the CLEAR
ALL/RESET button for 10 seconds, located in the
battery compartment of the display unit. Date and
time will need to be entered after a reset.
10
Possible Solution
Advertisement
Table of Contents
