Safety Notices; Warranty - Agilent Technologies NFA Series Setup Manual

Noise figure analyzers
Table of Contents

Advertisement

Safety Notices

The information contained in this document
is subject to change without notice.
Agilent Technologies makes no warranty of
any kind with regard to this material,
including but not limited to, the implied
warranties of merchantability and fitness for
a particular purpose. Agilent Technologies
shall not be liable for errors contained herein
or for incidental or consequential damages in
connection with the furnishing, performance,
or use of this material.
The following safety symbols are used
throughout this manual. Familiarize
yourself with the symbols and their meaning
before operating this instrument.
WARNING
Warning denotes a
hazard. It calls attention to a procedure
which, if not correctly performed or
adhered to, could result in injury or
loss of life. Do not proceed beyond a
warning note until the indicated
conditions are fully understood and
met.
CAUTION
Caution denotes a hazard.
It calls attention to a procedure that, if not
correctly performed or adhered to, could
result in damage to or destruction of the
instrument. Do not proceed beyond a caution
sign until the indicated conditions are fully
understood and met.
NOTE
Note calls out special
information for the user's attention. It
provides operational information or
additional instructions of which the user
should be aware.
The instruction
documentation symbol. The
product is marked with this
symbol when it is necessary
for the user to refer to the
instructions in the
documentation.
This symbol is used to mark the
on position of the power line
switch.
This symbol is used to mark
the standby position of the
power line switch.
This symbol indicates that the
input power required is AC.
WARNING
This is a Safety Class 1
Product (provided with a protective
earthing ground incorporated in the
power cord). The mains plug shall only
be inserted in a socket outlet provided
with a protected earth contact. Any
interruption of the protective
conductor inside or outside of the
product is likely to make the product
dangerous. Intentional interruption is
prohibited.
WARNING
If this product is not used
as specified, the protection provided by
the equipment could be impaired. This
product must be used in a normal
condition (in which all means for
protection are intact) only.

Warranty

This Agilent Technologies instrument
product is warranted against defects in
material and workmanship for a period of
three years from date of shipment. During
the warranty period, Agilent Technologies
will, at its option, either repair or replace
products which prove to be defective.
For warranty service or repair, this product
must be returned to a service facility
designated by Agilent Technologies. Buyer
shall prepay shipping charges to Agilent
Technologies and Agilent Technologies shall
pay shipping charges to return the product
to Buyer. However, Buyer shall pay all
shipping charges, duties, and taxes for
products returned to Agilent Technologies
from another country.
Agilent Technologies warrants that its
software and firmware designated by Agilent
Technologies for use with an instrument will
execute its programming instructions when
properly installed on that instrument.
Agilent Technologies does not warrant that
the operation of the instrument, or software,
ii
or firmware will be uninterrupted or
error-free.
LIMITATION OF
WARRANTY
The foregoing warranty shall not apply to
defects resulting from improper or
inadequate maintenance by Buyer,
Buyer-supplied software or interfacing,
unauthorized modification or misuse,
operation outside of the environmental
specifications for the product, or improper
site preparation or maintenance.
NO OTHER WARRANTY IS EXPRESSED
OR IMPLIED. AGILENT TECHNOLOGIES
SPECIFICALLY DISCLAIMS THE
IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE.
EXCLUSIVE
REMEDIES
THE REMEDIES PROVIDED HEREIN
ARE BUYER'S SOLE AND EXCLUSIVE
REMEDIES. AGILENT TECHNOLOGIES
SHALL NOT BE LIABLE FOR ANY
DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL
DAMAGES, WHETHER BASED ON
CONTRACT, TORT, OR ANY OTHER
LEGAL THEORY.

Advertisement

Table of Contents
loading

Table of Contents