Operation 2. TEACH Mode
2.7 Point Editor
This section describes settings in the [Point Editor] screen.
(1) Press the <F6> key in the [Jog & Teach] screen. The following screen appears.
(2) Set the data items currently displayed in the [Point Editor] screen.
(3) Note down the robot position.
(4) Back up the point data to a file.
2.7.1 Specifying Point Number
There are two ways to specify the point number.
(1) Specify the point number by changing the value in the [Point] using the <↑> and <↓>
(2) Change the [Point] values directly and press the <Enter> key.
2.7.2 Changing Point Label
(1) Press the <F1> key and move the cursor to [Label].
(2) Enter the label name at [Label] to set the name.
(3) Press the <Enter> key.
(4) Press the <OK> key to apply the memory.
46
Refer to : 2.7.1 Specifying Point Number
2.7.2 Changing Point Label
2.7.3 Changing Coordinate Data and Pose Flag
2.7.4 Deleting Point Data
Refer to : 2.1.10 Teaching
Refer to : 2.1.11 Saving Point File
keys.
Change the point number to change the indication at [Label].
Change the point number to change the indication at [Label].
TP1 Rev.8