Procom Lost River PCILVFD18RT Owner's Operation And Installation Manual page 20

8. Be sure the slide switch on the front of the
receiver box is in the ON position.
9. Turn control knob counterclockwise
to the ON position. The main burner
should light.
Note: If burner does not light, push the
slide switch on the receiver box to the OFF
position, then back to the ON position.
Note: Please wait one minute after shut-
ting off heater to allow the control valve
to reset before starting again.
10. Make sure fireplace screen is in place
before operating heater.
Ignitor Button
Figure 20 - Ignitor Button and Control
Knob Locations
Shutting Off Heater
Turn control knob clockwise
OFF position.
1. Follow steps 1 through 7 under Lighting
Instructions, page 19.
2. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
20
OPERATION
Control Knob
TO TURN OFF GAS TO APPLIANCE
to the
MANUAL LIGHTING PROCEDURE
www.usaprocom.com
11. If heater will not operate, follow the instruc-
tions To Turn Off Gas To Appliance, and
call your service technical or gas supplier.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: If input gas
type is NG, make sure NG pilot
burner ignites. If input gas type
is LP, make sure LP pilot burner
ignites.
Ignitor
Natural Gas
Electrode
Burner
Pilot Air
Inlet Hole
(Back of pilot
shown for clarity)
Figure 21 - Pilot
Shutting Off Burner Only
(pilot stays lit )
Turn control knob clockwise
PILOT position.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
4. Make sure the fireplace screen is in place
before operating heater.
Thermocouple
Propane/LP
Gas Burner
Pilot Air Inlet Hole
to the
200371-01B