Procom Lost River PCILVFD18RT Owner's Operation And Installation Manual page 22

Setting°F/°C Scale
The factory setting for temperature is °F. To
change this setting to °C, press the ON key
and the OFF key on the remote control at the
same time (see Figure 23, page 21). This will
change from °F to °C. Follow this same pro-
cedure to change from °C back to °F.
Manual Function
To operate the system in the manual "MODE"
do the following.
ON OPERATION
Press the ON key and the appliance flame will
come on. During this time the LCD screen will
show ON (see Figure 25).
After 3 seconds the LCD screen will default to
display room temperature and the word TEMP
will show (see Figure 25). The flame icon will
appear on LCD screen in manual on mode.
Figure 25 - Manual Mode in ON Operation
OFF OPERATION
Press the OFF key and the appliance flame
will shut off. During this time the LCD screen
will show OF (see Figure 26).
After 3 seconds the LCD screen will default to
display room temperature and the word TEMP
will show (see Figure 26).
Figure 26 - Manual Mode in OFF Operation
THERMOSTAT FUNCTION
Setting Desired Room Temperature
The remote control system can control the
thermostat when the transmitter is in the
THERMO mode. The word ROOM must be
displayed on the screen.
To set the THERMO MODE and desired room
temperature:
1. Press the MODE key until the LCD screen
shows the word ROOM. The remote is
now in the thermostatic mode.
22
OPERATION
2. Press and hold the SET key until the de-
sired set temperature is reached. The LCD
screen set numbers will increase from 45°
to 99° and then restart over at 45°.
3. Release the SET key. The LCD screen
will display the set temperature for 3 sec-
onds, then flash the set temperature for
3 seconds, then LCD screen will default
to display the room temperature.
To Change The Set Temperature
1. Press and hold the SET key until the
desired set temperature is reached. The
LCD screen set numbers will increase
from 45° to 99° then restart over at 45°.
2. Release the SET key. The LCD screen
will display the set temperature for 3
seconds, then flash the set temperature
for 3 seconds, then the LCD screen will
default to display the room temperature.
3. Press the MODE key to disengage the
thermo mode. The word ROOM on the
LCD screen will not show when the
thermo is not in operation.
TEMP
Note: The highest SET temperature is
99°F (32 °C) and the lowest temperature
is 45°F (6°C).
REMOTE CONTROL OPERATION
TEMP
The Thermo Feature on the transmitter op-
erates the appliance whenever the ROOM
TEMPERATURE varies a certain number of
degrees from the SET TEMPERATURE.
TEMP
This variation is called the "swing" or tem-
perature differential. The normal operating
cycle of an appliance may be 4 times per
hour depending on how well the room or
home is insulated from the cold or drafts.
The factory setting for the "swing number" is
TEMP
2. This represents a temperature variation of
+/-2°F (1°C) between SET temperature and
ROOM temperature, which determines when
the fireplace will be activated. The transmitter
has ON and OFF manual functions that are
activated by pressing either button on the
face of the transmitter. When a button on the
transmitter is pressed the word ON or OF will
appear on the LCD screen to show while the
signal is being sent. Upon initial use, there
may be a delay of three seconds before the
remote receiver will respond to the transmitter.
This is part of the system's design.
www.usaprocom.com
NOTES
200371-01B