Canon LASER CLASS 730i User Manual page 131

Message (Error code)
Fax Model NOT
AVAILABLE
PROBLEM READING CARD
REINSERT MEMORY CARD
PROBLEM READING CARD
TURN OFF AND ON
PUT IN CARTRIDGE
Fax Model
REC'D IN
MEMORY
Fax Model
TRY AGAIN IN
B&W (#085)
Fax Model
TX nnnn
SCANNING P. nnn
MEMORY FULL
PLEASE WAIT
Fax Model
TX/RX
CANCELLED
Fax Model
TX/RX NO.
nnnn
WAIT COOLING
WASTED INK NEAR FULL The waste ink tank is nearly full.
WRONG CARTRIDGE
Y INK EMPTY
12-22
Troubleshooting
Cause
In manual sending, you entered
a speed dialing number that is
assigned to a group.
The data on the memory card
may be inaccessible.
There is a problem with the card
slot.
There is no printhead installed in
the machine.
The machine received the fax in
memory because paper or ink
ran out, or a paper jam occurred.
You tried sending a color
document to a machine that
does not support color faxing.
The machine is sending a
document and its memory is full.
You pressed [Stop/Reset] to
cancel the transmission.
When the machine sends or
receives a fax, it assigns it a
unique identification number
(nnnn).
During printing, the printhead
may have become too hot.
The printhead is not installed
correctly.
The yellow ink tank in the
printhead is empty.
Action
Use regular dialing, or enter a
one-touch speed dialing key or coded
speed dialing code that only has one
fax/telephone number registered.
Check the data on the memory card in
your digital camera.
Try switching to another mode or
turning the machine off and on. If the
message remains, contact the Canon
Customer Care Center.
Install the printhead.
Load paper in the multi-purpose tray,
replace the ink tank(s), or clear the
paper jam.
Try sending again in black & white.
Alternatively, enable the <COLOR
DIRECT TX> setting.
The machine continues to send the
document as memory becomes
available.
If required, try sending or receiving
again.
Write the number down if you will
need it later.
Allow the machine to cool down. The
machine will resume printing when it
has cooled down.
If <CHECK PRINTER> appears, contact
the Canon Customer Care Center.
Try to reinstall the printhead. If the
message remains in the LCD, the
printhead may be defective. Contact
the Canon Customer Care Center.
Replace the ink tank.
Details
Chapter 7
Set-Up
Sheet
p. 3-7
p. 11-2
p. 12-15
p. 13-4
p. 11-2
Chapter 12