Smarttech SMART Room System SRS-LYNC-XS Setup Manual page 7

SETUP GUIDE
SMART ROOM SYSTEM WITH SKYPE FOR BUSINESS
To configure a SMART Board 8055i-G5 or 8065i-G5 interactive flat panel
a. Press the Input Select button
input source is HDMI.
b. Access the interactive flat panel's menu control panel:
IMPORTANT
For room systems with one interactive flat panel, temporarily remove the left speaker
o
to access the menu control panel.
For room systems with two interactive flat panels, temporarily remove both speakers
o
and the camera, and then move the right interactive flat panel to access the menu
control panels.
c. Press MENU.
d. Press the down arrow until you highlight the Setup menu, and then press SET.
e. Press the down arrow until you highlight Lync Room Reset, and then press SET.
f. Press MENU until the on-screen display menu closes.
NOTE
Completing steps c through f configures the interactive flat panel for use with the room
system.
g. If your room system has two interactive flat panels, repeat steps a to g for the second
interactive flat panel.
h. Continue to Procedure 3: Configuring Skype for Business Room System software first-run
installation settings on page 10.
7
on the interactive flat panel's front control panel until the
No. Name
1 MENU
2 SET
3 [Up]
4 [Down]
5 [Left]
6 [Right]
1026558 Rev 03