Procedure 3: Configuring Skype For Business Room System Software First-Run Installation Settings - Smarttech SMART Room System SRS-LYNC-XS Setup Manual

SETUP GUIDE
SMART ROOM SYSTEM WITH SKYPE FOR BUSINESS
Procedure 3: Configuring Skype for Business Room System software
first-run installation settings
To configure Skype for Business Room System software first-run installation settings
a. Select your language, and then click Next.
b. Select your country or region, time and currency preference, and keyboard layout, and then
click Next.
c. Type a user name for the local administrator's account and a computer name for the room
system appliance, and then click Next.
You must provide the administrator account's user name and password whenever you change
the room system's configuration or troubleshoot issues. The administrator account is only for
use with the SMART Room System and is not mapped or otherwise associated with user
accounts on your network.
In most configurations, the administrator's user name is "admin."
IMPORTANT
You must type a user name for the administrator account in the Type a user name box.
o
Do not leave this box blank.
Do not use "LyncRoom" for the administrator account's user name because this user
o
name is reserved.
d. Type a password for the administrator's ccount and a hint for that password, and then click
Next.
IMPORTANT
You must type a password for the administrator account in the Type a password box.
o
Do not leave this box blank.
Do not use special characters in the password that require the use of the ALT key to
o
type.
Record the administrator account's user name and password on page 3 or in another
o
safe place: If you forget the administrator account's user name and password, you will
have to reset the room system to the factory image, and then configuring the software
again.
10 1026558 Rev 03