Table of Contents
Advertisement
OPERATION OF YOUR OPENER
Your opener can be activated by any of the following
devices:
• Opener Control Panel: UP & DOWN buttons.
• Remote Control Transmitter: hold the button down
until the door starts to move.
• Wireless Entry Keypad: This is an optional
accessory that opens the door using a four digit
keycode.
• MyQ Internet Device: iPhone etc
When the opener is activated by remote control:
• If open, the door will close. If closed, the door will
open
• If closing, the door will stop
• If opening, the door will stop (allowing space for
entry and exit of pets and for ventilation)
• If the door has been stopped in a partially open or
closed position, it will reverse direction
Obstruction behaviour:
• If an obstruction is encountered while closing, the
door will reverse
• If an obstruction is encountered while opening, the
door will reverse and stop
• Obstruction detection beams use an invisible beam
which, when broken by an obstruction, causes a
closing door to open and prevents an open door
from closing. It is STRONGLY RECOMMENDED for
homeowners with young children or pets.
Opening the door manually:
The door can be opened manually by pulling the
release cord down firmly.
To re-engage the door, pull the release cord down
firmly.
The opener light will turn on for 3 minutes when
the opener is activated.
CARE OF YOUR OPENER
When properly installed, your opener will operate with
minimal maintenance. The opener does not require
additional lubrication.
Limit and Force Settings: These settings must be
checked and properly set when the opener is installed.
Weather conditions may cause some minor changes in
the door operation, requiring some re-adjustments,
particularly during the first year of operation. Refer to
limit and force setting in, section 13.
Follow the instructions carefully and repeat the
safety reverse test after any adjustment.
Transmitter: Additional transmitters can be purchased
at any time. Refer to chamberlaindiy.com.au or
chamberlaindiy.co.nz for compatible transmitters. Any
new transmitters must be programmed into the opener.
Transmitter battery: If the transmission range
decreases, replace the battery.
MAINTENANCE OF YOUR OPENER
Once a Month:
• Repeat the safety reverse test (see section 14).
Make any necessary adjustments.
• Manually operate the door. If it is unbalanced or
binding, call for professional garage door service.
• Check to be sure that the door opens and closes
fully.
Set the limits and/or force if necessary.
SPECIFICATIONS HANDYLIFT MYQ
(CR700MYQ)
Input Voltage:
Rated Load:
Max.Pull Force:
Max. door weight:
Max lift under Spring Tension: 15 kg
Max. door area:
Standby Power:
Drive:
Max. Drum Rotations:
Memory Registers:
Operating Frequency:
Operating Temperature:
21
220-240 VAC, 50-60 Hz, 140 W
35 Nm
500 N @ O300 mm
100 kg
2
16 m
< 1watt
DC gear motor permanent
lubrication
4
1/ 2
64
433.30/433.92/434.54 MHz
55
0
C to -25
0
C
Advertisement
Table of Contents
