Wiring - Chamberlain HandyLift MyQ Installation And Operating Instructions Manual

Garage roller door opener
Table of Contents

Advertisement

23
TYPICAL WIRING DIAGRAM HANDYLIFT MYQ (CR700MYQ)
Information for Service Personnel
24
Battery of the remote control:
REPLACE BATTERIES IN REMOTES
The batteries in the remote have a long life.
If the transmission range decreases, the batteries should be replaced. Batteries are not covered by the warranty.
To prevent SERIOUS INJURY OR DEATH: observe the following instructions for the battery
- NEVER allow small children near batteries.
- If battery is swallowed, immediately notify a Doctor.
- Danger of explosion if battery is replaced improperly.
- Replacement only by identical or equivalent type.
- Dispose of old battery properly. Batteries should not be treated as household waste. All consumers
are required by law to dispose of batteries properly at the designated collection points.
- Never recharge batteries that are not meant to be recharged.
- Do not short-circuit batteries or take them apart.
- If necessary, clean contacts on batteries and contacts before loading.
- Never expose batteries to excessive heat such as sunshine, fire or the like!
Replacing battery (CR2032 or equivalent):
To replace the battery, turn the remote control around
and open the case with a screwdriver. Lift the cover
and lift the control board. Slide the battery to one side
and remove the old battery. Be sure to observe the
polarity of the battery.
Assemble the transmitter again following the steps in
reverse.
green (4) grey (3)
4
3
External
Receiver
24 vdc
com
grey
Obstruction Detection Beams
white (2)
red (1)
2
2
1
white
or
22
com
n/o
Wired Wall Button
Pb
Cd
Hg

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cr700myq

Table of Contents