Operating Your Opener; Care Of Your Opener; Maintaining Your Opener; Specifications - Chamberlain RollerLift CR655MYQ Installation And Operating Instructions Manual

OPERATION OF YOUR OPENER
Your opener can be activated by any of the following
devices:
• Opener Control Panel: UP & DOWN buttons, and
O.S.C. control button.
• Transmitter: hold the button down until the door
starts to move.
• Wireless Entry Keypad: This is an accessory that
opens the door using a four digit keycode.
When the opener is activated:
• If open, the door will close. If closed, the door will
open.
• If closing, the door will stop.
• If opening, the door will stop (allowing space for
entry and exit of pets and for ventilation).
• If the door has been stopped in a partially open or
closed position, it will reverse direction.
Obstruction behaviour:
• If an obstruction is encountered while closing, the
door will reverse to the fully open position.
• If an obstruction is encountered while opening, the
door will stop and briefly reverse.
TM
• The Protector System
beam which, when broken by an obstruction,
causes a closing door to open and prevents an
open door from closing. It is STRONGLY
RECOMMENDED for homeowners with young
children or pets.
Opening the door manually:
When releasing the door, the door should
be fully closed if possible. Weak or
broken springs could allow an open door
to fall rapidly. Property damage or
serious injury could result.
The door can be opened manually by pulling the
release cord down firmly.
To re-engage the door, pull the release cord down
firmly.
The opener lights will turn on under the following
conditions:
when the opener is initially plugged in; when power
is restored after interruption or when the opener is
activated.The opener light will turn on for 3
minutes when the opener is activated.
SPECIAL NOTE: Chamberlain strongly recommends that The Protector System
garage door openers.
(IR Beams) use an invisible

CARE OF YOUR OPENER

When properly installed, your opener will operate with
minimal maintenance. The opener does not require
additional lubrication.
Limit and Force Settings: These settings must be
checked and properly set when the opener is installed.
Weather conditions may cause some minor changes in
the door operation, requiring some re-adjustments,
particularly during the first year of operation. Refer to
limit and force setting in Section 13.
Follow the instructions carefully and repeat the
safety reverse test after any adjustment.
Transmitter: Additional transmitters can be purchased
at any time. Refer to chamberlaindiy.com.au or
chamberlaindiy.co.nz for compatible transmitters. Any
new transmitters must be programmed into the opener.
Transmitter battery: If the transmission range
decreases, replace the battery.
MAINTENANCE OF YOUR OPENER
Once a Month:
• Repeat the safety reverse test (see Section 14).
Make any necessary adjustments.
• Manually operate the door. If it is unbalanced or
binding, call for professional garage door service.
• Check to be sure that the door opens and closes
fully.
Set the limits and/or force if necessary.
SPECIFICATIONS ROLLERLIFT
(CR655MYQ)
Input Voltage:
Rated Load:
Max.Pull Force:
Max. door weight:
Max lift under Spring Tension: 20 kg
Max. door area:
Drive:
Max. Drum Rotations:
Memory Registers:
Operating Frequency:
Operating Temperature:
TM
13
220-240 VAC, 50-60 Hz, 110 W
32 Nm
450 N @ O300 mm
80 kg
2
13 m
DC gear motor permanent
lubrication
4 1/ 2
64
433.30/433.92/434.54 MHz
55 0 C to -25 0 C
(IR Beams) be installed on all