STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2.
Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible in the
"Clear" fuel return line. Pump bulb an additional 4 or 5 times.
3.
Start - Pull Rope. Lay the edger on a flat clear area and pull
the recoil starter handle (D) until the engine fires.
DANGER
P
OWER
O
'
M
PERATOR
S
A
C
PE-231
PE-261
C
D
E
DGER
21
ANUAL