Table of Contents
Advertisement
4.
Recoil Starter
Lay the unit on a flat clear area. Firmly grasp right hand grip and
fully depress throttle trigger to wide open position. Rapidly pull
recoil starter handle/rope (D) until engine fires (or maximum five [5]
pulls).
5.
Choke
After engine fires (or five [5] pulls), move choke lever back to
"Run" position. Hold throttle trigger and throttle trigger lockout
fully depressed and pull recoil starter handle/rope until engine
starts and runs. Release throttle trigger and allow unit to warm up at
idle for several minutes.
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1.
Stop Switch
Move stop switch button (A) away from the STOP position.
2.
Primer
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line. Pump bulb an additional 4 or 5 times.
3.
Recoil Starter
Lay the unit on a flat clear area and pull the recoil starter handle (D)
until the engine fires.
DANGER
P
E
OWER
O
'
M
PERATOR
S
D
A
C
D
DGER
13
ANUAL
Advertisement
Table of Contents
