Starting Warm Engine; Stopping Engine - Echo PE-2601 Operator's Manual

18
4. Start - Pull Rope.
Lay the edger on a flat clear area and pull the recoil starter handle
(E) until engine fires.
5. Open Choke - Run.
Move the choke lever to the OPEN - RUN position. Restart engine
if necessary and allow to warm up running at idle for several
minutes.

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible
in the "Clear" fuel return line (D).
3. Start - Pull Rope. Lay the edger on a flat clear area and pull
the recoil starter handle (E) until the engine fires.

STOPPING ENGINE

1. Release Throttle. Allow engine to idle for a minute.
2. Stop Switch - Stop. Move stop switch button (A) backward to
STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using edger
again.
DANGER
DANGER
E
A
E
D
C
A