This adds additional rigidity to the unit. Using other glue types may a ect curing and workablity time. PAGE 2 OF 8 QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601 MODEL NO. BMS...
Page 3
+1 (833) 530-0033 STOP Watch our assembly video at: Need Help? sprout-kids.com/bmsa This is also on pg. 2 under “Before You Start”. Are both needed/which can be deleted? ASSEMBLY INSTRUCTIONS Push tabs on Toes a into slots on bottom b . Tabs and slots must be lined up correctly or they will not properly tighten.
Page 4
Remove excess glue from joints with a damp cloth. If unable to get parts to be ush with each other dissassemble immediately. Remove glue with a damp cloth and contact Customer Service. PAGE 4 OF 8 QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601 MODEL NO. BMS...
Page 5
Parts will be snug. Remove excess glue from joints with a damp cloth. Carefully set shelving unit upright. Remove excess glue with damp cloth. Check that everything is fully tightened. PAGE 5 OF 8 DOCUMENT: AI-B.2-NoBack WWW.SPROUT-KIDS.COM COPYRIGHT QUARK ENTERPRISES 2018...
Place one of the brackets into the corner on the underside of the shelf like so. The triangular face of the bracket should be against the toe piece. PAGE 6 OF 8 QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601 MODEL NO. BMS...
Page 7
Install 2 more screws into the holes on one of the small sides of the bracket, then the other. Repeat for the other 3 corners. Allow glue to set for 1 hour before use. DOCUMENT: AI-B.2-NoBack WWW.SPROUT-KIDS.COM COPYRIGHT QUARK ENTERPRISES 2018 PAGE 7 OF 8...
Page 8
Simple. Modern. American Made. PAGE 8 OF 8 QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601 MODEL NO. BMS...
Need help?
Do you have a question about the BMS and is the answer not in the manual?
Questions and answers