Switch On Settings - Philips BFL2114/12 Series Professional Installation Manual

6.4 Switch on settings

MHz. So, if you do a playout on another
frequency as set in the TV, the TV will do
a fallback scan in order to find it. Make
sure the frequency is not used by any
other tv-, radio- or data mux.
o [Scan Mode]: Define when the TV shall
scan the RF stream for updates
▪ When [Legacy] is selected, then the
RF scan for upgrades will happen 5
minutes after the TV is set to STBY,
1PM and at 4AM when the TV is not
in use
▪ When [Standby] is selected, the TV
will scan continuously when the TV
is in standby and [Standby Mode]
set to [Fast]
▪
When [Standby and On] is selected,
the TV will scan continuously when
the TV is in standby and also when
in on state. When in on state, in
order to be able to upgrade, the tv
needs to be tuned to the RF playout
frequency, for example when an AV
stream is being used in CMND and
the tv is tuned to it
Note: in order to set the [Scan Mode],
the TV must be in [Fast] mode. In Green
mode, the TV will always follow the
[Legacy] scanning
Note: TV will stop the upgrade if TV
would be woken up by the user during
the upgrade
o Navigate to the [Switch on Settings]
menu, you will see the screen on the left
o In this menu you will be able to set all
Switch on settings, these are the menu
items that a user can change, the values
you set here are the settings applied when
the user wakes up the TV
- 33 -