Philips BFL2114/12 Series Professional Installation Manual page 71

fast standby mode immediately after
cold boot, this also enables the 5V on
USB immediately after cold boot.
Note: This menu is only accessible if
[Standby Mode] is set to [Fast]
o [Auto Standby]: If any value bigger
than [0] is set, the TV will go to STBY by
itself after 10 minutes if no video signal
is there. If there is video signal, the TV
will go to STBY if no user interaction is
there for the time set using the slider
between [30] and [240] minutes. You
can also put this [0] to disable the TV to
go to STBY.
o [LED Power Indicator]: If [On], the
power LED will be red while the TV is in
standby. When [Off], there will be no
power LED indication.
o Navigate to the [Security] menu
o You will see below items:
o [Professional Menu PIN Lock]: When
[On] you can set a 5 digits PIN code to
lock the professional menu, when
entering the professional menu using
the key sequence you will need to
enter the 5 digits, when [Off], this is
disabled
o [Professional Menu Keyboard Access]:
When [On], you will be able to use the
"F9" key on your keyboard to access
the professional menu using the
TeamViewer application or when you
have a keyboard connected to the TV.
When set to [Off], you will not be able
to access the professional menu via the
"F9" key on the keyboard.
Note: Some behavior will be depending
on your keyboard. In general, you will
be able to navigate using the arrows
and exit a menu using the Esc key
o [High Security]: When [On], the
professional setup menu can only be
accessed by the Master RC and not
using the key sequence via a User RC,
when [Off] you can use both
- 70 -