Confi Gure The Switch On Settings; Confi Gure The Control Settings - Philips 39HFL3684S/F7 Quick Start Setup Manual

Confi gure the Switch on settings
1
Press MENU and select Switch on settings.
2
Press Î or ï to select the desired mode, then press
OK.
Switch on Defi nes the pre-set volume level when TV is powered
volume on.
Maximum
Defi nes the maximum limit of volume level except for
volume the external set top box.
Switch on Defi nes the power-on channel number or external
channel
video input.
Determines the state of the TV when the AC power is
provided or restored.
Powers on TV after the AC power is restored.
On
(digital signage application)
Power on
Standby TV enters standby mode. (hospitality)
Last
Returns TV to the same state as before
status power was interrupted. (general use)
Confi gure the Control settings
1
Press MENU and select Control settings.
2
Press Î or ï to select the desired mode, then press
OK.
TV RC Sets the TV operative or inoperative by guest remote
locked
control.
Sets the TV operative or inoperative by local keyboard.
The control buttons on the TV are disabled
On
except for the Power button.
TV keys
The control buttons on the TV are enabled
locked
Off
and function normally.
All the control buttons on the TV are disabled
All
including the Power button.
Enable or disable to display the "On Screen Display".
When you select Off, those settings below cannot be
displayed on TV.
- channel number / label / name
OSD
- "channel not valid" information
display
The rest of menus such as CC, Guest menu, Setup
Menu, Status Menu, Splash Screen, Sleep Timer, Sleep
warning Message, Freeze, Child lock Message and USB
Media Playback menu, etc. are still displayed.
EcoPower Sets the TV to reduce the power consumption.
Choose the SPI port connected to the external set
top box.
Off
SPI Port is disabled.
SPI Port
SPI Port is enabled with the data and clock
3V3
line being pulled high to 3.3V voltage idle.
SPI Port is enabled with the data and clock
5V
line being pulled high to 5V voltage idle.
Choose the standby mode when the TV goes into the
standby mode. When SPI Port is switched to 3V3 or
5V, Standby mode should be set to Fast to support all
the relevant SPI Port commands.
While the TV is turned off in this mode, the
Standby
SPI functionality is limited. Once turned on,
mode
Green complete SPI functionality is restored. Refer
to the full User Manual for more complete
information.
While the TV is turned off in this mode,
Fast
complete SPI functionality is maintained.
Enable or disable to support the feature of the USB
USB
media playback. The USB cloning feature is always
playback
enabled, regardless of this setting.
MultiRC Enables control of multiple TVs in a room without any
interference from each other's remote control.
Note
•
Supported USB Playback formats:
<JPEG>
Upper limit : 24Mpixel
<Motion JPEG>
Size : 320 x 240 (QVGA)
Frame rate : 30fps
Audio type : LPCM - Sampling frequency
9
(32 kHz, 44.1 kHz or 48 kHz)
- Quantization bit rate (16 bit)