Technical Data; Installation - Electrolux ERZ45800 User Manual

26 electrolux
Problem
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover (refer to the illus-
tration).
3. Replace the used lamp with a new lamp
of the same power (the maximum power
is shown on the lamp cover).
4. Connect the mains plug to the mains
socket.
5. Open the door. Make sure that the lamp
comes on.

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
Possible cause
The door is not closed correctly.
Height
Width
Depth
Refer to "Closing the door".
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1900 mm
860 mm
550 mm
14 h
mate class indicated on the rating plate of the
appliance:
Solution