Table of Contents
Advertisement
Note: Before proceeding to the following steps, please revisit
steps with asterisks and use a wrench to tighten all hardware
that was originally hand tightened. Failure to tighten all
hardware as described can cause damage to the Tornado Boat
Lift and/or serious injury/death.
MOUNT ALUMINUM MULTI-BUNK
1.
Align the 3/8" holes in the Aluminum Multi-Bunk with the
corresponding mounting holes on the V-Bunk Brackets.
2.
Insert one (1) 3/8" Flat Washer over two (2) 3/8" Hex Bolts
and insert them into the holes on the Bunk as shown in
Figure 21.
3.
Attach one (1) 3/8" Lock Nut and one (1) 3/8" Hex Nut to the
protruding ends of the Hex Bolts and tighten with
appropriate wrench.
4.
Repeat these steps seven (7) more times, once for the other
side of the Bunk, and six more times for the other Bunks.
Figure 21
PARTS REQUIRED TO MOUNT ALUMINUM
3/8" Flat Washer (32)
3/8" x 5" Hex Bolt (16)
19
MULTI-BUNK
Aluminum Multi-Bunk (4)
3/8" Lock Washer (16)
3/8" Hex Nut (16)
Advertisement
Table of Contents
