Attach V-Bunk - Golden Tornado 8-CYLINDER Installation Manual

ATTACH V-BUNK**

1. Align the bracket of the V-Bunk so it is resting on top of the
V-Bunk Support.
2. Attach one (1) 3/8" Flat Washer to two (2) 3/8" Hex Bolts and
insert the Hex Bolts into the corresponding holes on the V-
Bunk as shown in Figure 18.
3. Attach one (1) Lock Washer and one (1) Hex Nut to the
protruding ends of the Hex Bolts and hand tighten.
Note: It is important not to over tighten Hex Nuts to allow for
adjustability.
4. Repeat these steps seven (7) more times, once for the other
side of the V-Bunk, and six more times for the other V-
Bunks.
Note: Please return to this step when instructed to fully tighten
hardware.
Figure 18
PARTS REQUIRED TO MOUNT V-BUNK
3/8" Flat Washer (32)
3/8" x 4-1/2" Hex Bolt
(16)
Figure 19
17
V-Bunk (4)
3/8" Lock Washer (16)
3/8" Hex Nut (16)