Mount Middle H-Frame - Golden Tornado 8-CYLINDER Installation Manual

MOUNT MIDDLE H-FRAME

Note: For this step, ensure both Middle H-Frames are being used.
Note: Ensure the smaller Middle H-Frame (64-7/8") is mounted
closer to the Bow Side H-Frame and the larger Middle H-Frame
(65-1/2") is mounted closer to the Stern Side H-Frame.
Note: Hinge Bushings are preinstalled on Side Beam.
1. Align the mounting holes on the Middle H-Frame hinge plate
with the Hinge Bushings located on the Side Beam as shown
in Figure 12.
2. Insert one (1) 1/8" Cotter Pin into one (1) 1" Hinge Pin, bending
the tines of the Cotter Pin outward and apart, securing the
Cotter Pin within the Hinge Pin.
3. Attach a Lollipop Washer to the open end of the Hinge Pin.
4. Slide the Hinge Pin through the hinge plate as shown in
Figure 12.
5. Insert one (1) Lollipop Washer and one (1) 1/8" Cotter Pin into
the protruding end of the Hinge Pin, bending the tines of the
Cotter Pin outward and apart, securing the Cotter Pin within
the Hinge Pin.
6. Repeat these steps three (3) more times, once for the
opposite side of the Middle H-Frame, and twice for the
second Middle H-Frame.
PARTS REQUIRED TO MOUNT MIDDLE H-
Lollipop Washer
(8)
1" x 5-3/8" Hinge Pin (4)
13
FRAME
Middle H-Frame (2)
1/8" Cotter Pin (8)