Attach V-Bunk Bracket - Golden Tornado 8-CYLINDER Installation Manual

ATTACH V-BUNK BRACKET**

1. Align the 1/2" holes of the V-Bunk Brackets so that they are
above and below the V-Bunk arm as shown in Figure 20.
2. Attach one (1) 1/2" Flat Washer over two (2) 1/2" Hex Bolts
and insert them into the corresponding holes as shown in
Figure 20.
3. Attach one (1) 1/2" Lock Washer and one (1) 1/2" Hex Nut over
the protruding ends of the Hex Bolts and hand tighten.
Note: It is important not to over tighten Hex Nuts to allow for
adjustability.
5. Repeat these steps seven (7) more times, once for the other
side of the V-Bunk, and six more times for the other V-
Bunks.
Note: Please return to this step when instructed to fully tighten
hardware.
Figure 20
PARTS REQUIRED TO MOUNT V-BUNK
1/2" Flat Washer (32)
1/2" x 4-1/2" Hex Bolt
(16)
18
BRACKET
V-Bunk Brackets (16)
1/2" Lock Washer (16)
1/2" Hex Nut (16)