Attach Inner Foot Pads - Golden Tornado 8-CYLINDER Installation Manual

ATTACH INNER FOOT PADS**

Note: Please use the two (2) Foot Pad & Square Tube Leg
assemblies prepared in previous step.
1. Slide the Square Tub Leg into the Middle Leg Support and
align the mounting holes at desired height as shown in
Figure 7.
Note: The Middle Leg Support open-end bracket should be facing
upward.
2. Attach one (1) 3/8" Flat Washer to one (1) 3/8" Hex Bolt and
insert into the mounting holes at desired height.
3. Slip one (1) 3/8" Lock Washer, one (1) 3/8" Flat Washer, and
one (1) 3/8" Hex Nut over the protruding end of the Hex Nut
and securely fasten with appropriate wrench until secure.
4. Slide the Middle Leg Support bracket underneath and
upward around the Side Beam so that the mounting holes
are above the Side Beam as shown in Figure 8.
5. Attach one (1) 3/8" Flat Washer over two (2) 3/8" Hex Bolts
and insert them into the mounting holes on the Middle Leg
Support bracket as shown in Figure 8.
6. Slip one (1) 3/8" Lock Washer, one (1) 3/8" Flat Washer, and
one (1) 3/8" Hex Nut over the protruding end of the Hex Bolts
and hand tighten.
7. Repeat these steps one (1) more time for the other Foot Pad
and Square Tube Leg
Note: Please return to this step when instructed to fully tighten
hardware.
Figure 7
PARTS REQUIRED TO ATTACH INNER FOOT
3/8" Flat Washer (12)
3/8" x 4-1/2" Hex Bolt
(6)
10
PAD(S)
Middle Leg Support (2)
3/8" Lock Washer (6)
3/8" Hex Nut (6)
Figure 8