Installing The Ductwork And Grilles; Recommended Insulated Flexible Ductwork Sizing Chart - Wine Guardian D088V Installation, Operation And Maintenance Manual

Installing the Ductwork and Grilles

Use ductwork to connect the unit to the supply and return outlets in the wine cellar. Use only
insulated ductwork to minimize cooling loses, prevent sweating, and to reduce noise.
Use ductwork on the condenser section to redirect or absorb sound, to bring in outside air to the unit
inlet, and/or to exhaust the hot air out of the ambient space.
NOTE: Do not exceed a total of 25 feet for combined supply and return duct work

Recommended Insulated Flexible Ductwork Sizing Chart

For 60Hz models
Evaporator (cooling) Coil
Model#
8"
D025
10"
D050
10"
D088
12"
D200
D050V 10"
D088V 10"
For 50Hz models
Model Inlet
WG40 200
WG75 250
WG100 250
WG175 300
Notes:
1. The above referenced 60 Hz sizes are internal diameter in inches and the 50Hz are
in millimeters (mm)
2. If a single supply is used out of the unit but then splits into two ducts, the size above
that is recommended for double is used after the
Inlet Outlet
(Return (supply
Air) air)
Single Double
8"
10"
10"
12" 10"
10"
10"
Evaporator Coil
Single Double
Outlet Outlet
200 150
250 200
250 200
300 250
Part No. 15H0127-00
Condenser (heat rejection) Coil
6" 8"
8" 10"
8" 10"
12"
8" 10"
8" 10"
Condenser Coil
Single
Outlet
Inlet
200 200
250 250
250 250
300 300
split.
Inlet Outlet
Single Double
8" 6"
10" 8"
10" 8"
12" 10"
10" 8"
10" 8"
Double
Outlet
150
200
200
250
49