Advanced Settings--
Compressor anti-
short cycling time
Set up remote sensor
or thermostat
Enable or disable
defrost sensor input
Setting 8
Press "Settings" button to advance to Setting
8.
Press the "up" or "down" arrow buttons to
adjust number to the access code 12. Press
"Settings" button to continue onto Setting 9
through 19.
Setting 9
Press "Settings" button to advance to Setting
9.
Press the "Up" or "Down" arrow buttons to
adjust to the desired time in one-minute
increments. Maximum is 10 minutes,
minimum is 0 minutes.
Compressor anti-short cycling time is the
amount of allowable time between compressor
stop and restart. Rapid start/stop of compressors
can cause premature failure. Factory default is 5
minutes.
WINE GUARDIAN DOES NOT
RECOMMEND SETTINGS LOWER THAN
FACTORY DEFAULT.
Setting 10
Press "Settings" button to advance to Setting
10.
Press the "Up" or "Down" arrow buttons to
adjust to the desired setting.
rS = Remote sensor
rI = Remote interface
LI= Local interface – Through-the-wall unit
only
A = Averaging – Jumper position within
sensors must be adjusted. See page 43.
Setting 11
Press "Settings" button to advance to Setting
11.
Press the "Up" or "Down" arrow buttons to
adjust to the desired setpoint
1 will equal enabled and a 0 (zero) will equal
disabled.
Part No. 15H0127-00
45