Table of Contents
Advertisement
Quick Links
Wine Cellar Cooling Systems
Humidifiers – Integrated and Freestanding
Installation, Operation and Maintenance Guide
60 and 50Hz Models
Manufactured by:
Syracuse, NY
www.wineguardian.com
www.airinnovations.com
Wine Guardian reserves the right, without notice, to make changes to this document at its sole discretion.
Please visit out web site for the most current version of the Wine Guardian manual and other literature.
Wine Guardian is a registered trademark (2,972,262) of Air Innovations, Inc.
Edition 06/2021
© Air Innovations, 2021
Part No. 15H0164-00
0
Advertisement
Table of Contents
Related Manuals for Wine Guardian 99H0174-00
Summary of Contents for Wine Guardian 99H0174-00
- Page 1 Wine Guardian reserves the right, without notice, to make changes to this document at its sole discretion. Please visit out web site for the most current version of the Wine Guardian manual and other literature. Wine Guardian is a registered trademark (2,972,262) of Air Innovations, Inc.
-
Page 2: Table Of Contents
Installation with Freestanding Model ............13 Freestanding Installation ................14 Wine Guardian-Mounted (Integrated Installation) ........15 Attaching Humidifier to Ducted Wine Guardian unit (integrated installation)..... 16 Location of WG Unit Connection for Communication Cable from Humidifier ..... 16 Controller Set-Up Instructions ..............17 Mounting the Humidistat ................ -
Page 3: Directory Of Terms
SP – static pressure. Unit of measurement (in inches of water column) of the pressure of the air being handled by the fan. Supply/Discharge Air – the air leaving the Wine Guardian unit and going into the cellar from the evaporator section. Also the air leaving the condenser section. -
Page 4: Introduction
This guide is intended to help the installer and owner of the Wine Guardian Humidifier to properly install and maintain the equipment. In order to ensure optimal performance, the equipment should be installed properly and have proper care and maintenance. -
Page 5: General Description
Your Wine Guardian Humidifier has a communication cable that gets wired directly to the side of the Wine Guardian unit, a drain line that requires piping to an open floor drain or condensate pump and water fill line. -
Page 6: Size And Capacity
ALONG WITH THIS GUIDE FOR FUTURE REFERENCE. Size and Capacity The Wine Guardian Humidifier uses a 10” wide x 11” high x 2” thick (254mm wide x 780mm high x 51mm thick) expanded coated aluminum pad. Its rated output capacity for wine cellars is 0.42 lbs/HR (0.19 kg/HR) using 100°F (38°C) supply water. -
Page 7: Overview
Overview (Refer to call-outs on Fig. 2.0) Adapter plates – metal plates used to mount the humidifier to the different sizes of Wine Guardian cooling units. Refer to Fig. 5 on page 16. Humidifier Housing – the cabinet and access doors are constructed of ABS (Acrylonitrile Butadiene Styrene) plastic. -
Page 8: Overview Drawing With Callouts
Overview Drawing with Callouts Figure 1.0... -
Page 9: Dimensional Drawing
Dimensional Drawing Figure 2.0... -
Page 10: Wiring Diagram - Integrated Humidifier (60Hz / 50Hz)
Wiring Diagram - Integrated Humidifier (60Hz / 50Hz) igure 3.0... -
Page 11: Wiring Diagram - Freestanding Humidifier (60Hz)
Wiring Diagram - Freestanding Humidifier (60Hz) Figure 3.1... -
Page 12: Wiring Diagram - Freestanding Humidifier (50Hz)
Wiring Diagram - Freestanding Humidifier (50Hz) Figure 3.2... -
Page 13: Safety
Safety The Wine Guardian Humidifier uses 24-volt power through a 120-volt transformer plug or digital control through the Wine Guardian main control unit. CAUTION BE SURE TO DISCONNECT THE MAIN POWER TO THE COOLING UNIT OR TO THE HUMIDIFIER. THE POWER PLUG OR COMMUNICATION CABLE SHOULD BE DISCONNECTED AT ITS SOURCE BEFORE SERVICING. -
Page 14: Installation With Freestanding Model
Installation with Freestanding Model Stand Alone Humidifier Installation Options Figure 4.0... -
Page 15: Freestanding Installation
Wine Guardian unit at this time. The communication cable provides power and control signals to humidifier from Wine Guardian main control panel. 7) Proceed to set up of the Remote or Local Interface Controller at Wine Guardian unit to re- program for humidity control. -
Page 16: Wine Guardian-Mounted (Integrated Installation)
A shut off valve (not provided) is recommended to isolate the humidifier from the water system when needed. 7) Connect the communication cable to the side of the Wine Guardian system as shown in Figure 6 on the following page. The communication cable provides power and control signals to the humidifier from the Wine Guardian main control panel. -
Page 17: Attaching Humidifier To Ducted Wine Guardian Unit (Integrated Installation)
Attaching Humidifier to Ducted Wine Guardian unit (integrated installation) Location of WG Unit Connection for Communication Cable from Humidifier Figure 6.0... -
Page 18: Controller Set-Up Instructions
Controller Set-Up Instructions 1. Locate the Wine Guardian remote interface controller (Fig B.) within the wine cellar or proceed to the Wine Guardian Local Interface Controller main control panel. (Fig. A) Fig A Fig B. 2. Press the Settings button and hold it down for five (5) seconds.