Table of Contents
Advertisement
TOP VIEW
Handle
Front Cover
M5 PH Bolt 6ea
Front Protection Cover
13
17. Plate the Wall Mounting Bracket Top
Support in right plate as shown in
fi gure and fi x on Battery Control Unit
using three (3) M6 Flange Bolts
* Tighten the M6 Flange Bolts with a
torque of 5Nm.
18. Re-attach the top cover.
* Tighten the M5xL65 Flange Bolt
(4ea) with a torque of 5N·m.
19. Open the front cover.
* Hold the handle and turn it
counterclockwise.
20. Loosen 6 bolts and remove the Front
Protection Cover.
* Be careful not to drop the bolts into
the pack at this stage.
21. Assemble the adapter or cap
according to regional regulations.
Insert the RMD ethernet cable
through Hole #2 and connect the
cable. Then proceed to Section 3.2
Installation for Remote Monitoring
Device (RMD).
Hole #2
Hole #1
Connector for
Ethernet cable
22. Assemble the adapter or cap
according to regional regulations.
Then insert the power and
communication cables through the
holes from outside of the pack.
* Arrange the internal cable as
required to avoid blocking the holes
for external cables.
Internal cable
Hole #2 Communication cable
Hole #1 Power cable
23. Connect the cables according to their
application.
* Refer to Section 3.3 Cable
Connections.
24. Arrange the power cables and
communication cables separately
using cable ties.
Advertisement
Table of Contents
