LG HBP10H Installation Instructions Manual page 11

3.1.9.2 Wall Mounting Type (Optional)
Wall
Wall
Rear
Front
Top View
Wall
Bottom View
Battery
Module B
R e a
n t
F r o
r
Label
Wall
Battery Module Direction
R e a
n t
r F r o
Spacer
(used for assmbly ang disassembly)
11
1. Place the Drill template to the wall
where the battery pack will be
installed. After that, drill holes on the
position marked on the Drill template.
* The number of fastener should
observe the regional building code.
LGES recommends the use of at
least 8 fasteners for Wall Mounting
Bracket Bottom and 2 fasteners for
Wall Mounting Bracket Top.
* Check "LG HBP10H Wall
Mounting (Optional)" on the
middle side of Drill Template
before drilling.
2. Fix the Wall Mounting Bracket
Bottom and Wall Mounting Bracket
Top on the wall.
F r o
3. Place and fi x the Module Connect
n t
Plate on the Wall Mounting Bracket
Bottom using eight (8) M8 Sems
Bolts.
* Tighten the M8 Sems Bolts with a
torque of 5Nm.
4. Place Battery Module B on the rear
side of Module Connect plate.
* The side without bolts is the front
of the Battery Module.
* Check the label to confi rm the
battery pack is of B. Label is
attached on the left side of Battery
Module.
TOP
Battery Module A
F r o
n t
n t
F r o
Label
Wall
Battery Module B
Rear
Front
Battery Module A
F r o
TOP VIEW
n t
F r o
n t
Module Support BRKT
Battery Control Unit
Battery Modules
TOP
Spacer
(used for assmbly ang disassembly)
5. Place Battery Module A on the front
side of Module Connect plate. The
Rear side of each Battery Module
should face each other.
* Check the label to confi rm the
Battery pack is of A. Label is
attached on the left side of Battery
Module.
F r o
n t
6. Assemble Module Support BRKTs
using 6 bolts each.
* Tighten the M6 Flange Bolts (x12)
with a torque of 5N·m.
7. Remove bubble wrap from
connectors of Battery Control Unit
and the warning label of Battery
Modules.
8. Place the spacers on the position
marked with label on Battery
Modules.