FEATURES AND OPERATION
Hand Control — Memory Programming & Special Functions
— Two programmable positions for storing commonly use table positions.
To Program:
Move table to desired position for memory storage.
1
Press and hold (approximately 3 seconds) desired memory position button (M1 or M2) in which table position is to be
2
stored. An audible double beep should be heard indicating table position has been programmed.
To use memory function, press and hold the memory button (M1 or M2) for 1 second. Table will return to programmed
3
position.
Holding the memory button (M1 or M2) for 3 seconds when performing step 3 will cause the memory button to re-program
to the current position of the table.
— Stops table movement when any impulse movements (HOME, Memory Function M1 or M2) are being
used.
Simultaneous movement
›
Press any combination of buttons for simultaneous movement of multiple functions
Simultaneous Movement
(shown as an example)
Memory Positions
4040-650
Pressing any button on the hand or foot control will cancel table movement.
Stop Control
4070-650
8