Setting Up Your Strobe
Removing the Battery Pack
»
The battery pack is NOT waterproof when detached from the
strobe front.
1. Turn the Power Switch to the OFF position and place the strobe
face down on a fl at surface.
2. Slide the toggle lock out and fl ip up.
3. Rotate the toggle lock counter-clockwise 90 degrees.
4. Remove the Battery Pack from the strobe front.
Attaching the Battery Pack
»
Never attach a water damaged battery pack to a strobe. Use of
a water damaged battery pack is a safety risk and can cause
damage to the strobe electronics.
1. Turn the Power Switch to the OFF Position and place the strobe
face down on a fl at surface.
2. Check that the o-ring is in place and that the sealing surfaces are
clean. It is not necessary to lubricate the o-ring.
8