Ikelite DS160 Manual page 17

•
Adjust aperture (larger), shutter speed (slower), or ISO (lower)
setting.
•
Move strobe(s) closer to your subject and check aiming.
Strobe will not fi re when using sync cord.
•
Make sure the strobe is turned on.
•
Try a different sync cord.
•
Restore camera to factory default settings and then re-confi gure
according to the housing instructions.
Strobe will not fi re when using an optical sensor.
•
Make sure the strobe is turned on.
•
Test fi re the strobe through the bulkhead. If it does not fi re through
the bulkhead, then the strobe must be returned for repair.
•
Make sure the signal fl ash is fi ring.
•
Make sure the strobe sensor is pointed directly towards the signal
fl ash.
•
Move the strobe sensor closer to the signal fl ash.
Ready light does not come on.
•
Charge or replace battery pack.
•
Make sure the strobe is turned on.
Backscatter or "snow" in images.
•
Position your strobe(s) farther away from your lens and at a slight
angle.
•
Avoid using strobes in extremely low-visibility conditions.
17