Advertisement
Mobile Pedestal Casters &
Free Standing Pedestal Glides
Installation
Note: Four plate-mounted casters
or glides and a small anti-tip
caster are provided for installation
to the base of the pedestal. The
plate mounted casters or glides
are installed in the four corners.
The small caster will fasten to the
lower drawer bracket, if included.
1. Carefully lay pedestal onto a soft
protective surface, on it's
back-side as illustrated
(Figure 4).
2. Slide each caster or glide plate
to nest into the formed tabs
under the appropriate corner of
the pedestal. Properly nested,
a single mounting hole in the
base of each corner caster will
align with a pre-drill hole in
the underside of the pedestal.
Secure each caster or glide to the
underside of the pedestal with one
#10 x
/
" screw (Figure 4).
1
2
3. If applicable, extend the bottom
drawer of the pedestal out to
expose the center caster mount.
Fasten the anti-tip caster to the
drawer bracket and secure firmly
in place with the
/
-18 lock
5
16
washer nut.
1330 Bellevue Street • P .O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
2 / "
13
16
Figure 3
#10 x / "
1
2
screw
caster
#10 x / "
1
2
screw
mounting
front/center
plate
caster (small)
caster
Figure 4
front/center
caster (small)
© 2015 Krueger International, Inc. All Rights Reserved • Code KI-62569/KI/PDF/0715
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
9 / "
3
8
9
1 / "
1
1 / "
16
2 / "
13
16
7 / "
1
2
9 / "
3
8
1 / "
9
1 / "
1
16
16
7 / "
1
2
5
/ -18 lock
16
washer nut
mounting
plate
5
/ -18 lock
16
washer nut
21150-2
U-Series Pedestals
Assembly Instructions
front edge of worksurface
16
front edge of worksurface
pedestal
pedestal
Door
8. Th
block
upper
make
3, De
Note:
3/4" s
brack
instal
2
Advertisement
