Sony DSBK-100 Operating Instructions Manual page 16

Installation
8
Remove the two screws and
washers from the cover plate
on the rear panel of the DSR-
60/60P. Slide the cover plate
to the right, then remove it.
Note
Retain the cover plate.
9
Feed the two cables out
through the holes exposed
when the cover plate is
removed, and connect them to
the connector panel, one of the
components of the DSBK-100/
100P.
Note
Be careful to match the cable
connector colors, and connect
them in the sequence shown in
the figure.
10
Attach the connector panel to
the rear panel of the DSR-60/
60P.
Pulling the cables back through
the holes, slot the connector
panel into position, then slide it
to the left. Fasten the
connector panel with the two
screws and washers removed
in step 8.
16
Cover plate
Red connector
Black connector
Connector panel