9: Configuring The Network Settings Of The Receiver - Sony STR-DA5500ES Operating Instructions Manual

9: Configuring the
network settings of the
receiver
The network settings for the receiver must be
set correctly to use the network functions of
the receiver.
You can make the required network settings
for the receiver by following the instructions
provided by an initial setup wizard.
The procedure used to set up the IP address
automatically (DHCP) is explained below.
In this case, the router that is connected to the
receiver or the Internet provider must support
DHCP.
1
Press MENU.
The menu is displayed on the TV screen.
2
Press V/v repeatedly to select
" Settings," then press
b.
3
Press V/v repeatedly to select
"Network," then press
4
Press V/v repeatedly to select
"Network Setup," then press
"Start Network function Setup Wizard"
appears on the TV screen.
5
Press
6
Press
Automatically (DHCP)."
"Success! The receiver is now connected
to network." appears on the TV screen
when you have succeeded in making a
connection.
If the failure screen is displayed, perform
the process referring to "Network Setup"
(page 144), after you have completed this
process.
7
Press
To set the network settings
manually
V/v/b,
See "To set the IP address manually"
(page 144) or "To set the Proxy server
manually" (page 144).
MENU
Note
The wizard screen appears on the TV screen each
time you use the network function, until the network
function setup has been completed.
or
.
to select "Next."
to select "Connect
to select "Finish."
or b.
57 GB