Sony STR-DA5500ES Operating Instructions Manual page 190

HDMI function does not work properly for
a long time, perform the steps given in
"Preparing for the "BRAVIA" Sync"
(page 112).
• When you select "HDMI B" or "OFF," the
Control for HDMI function does not work
properly.
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the "Audio Out"
settings in HDMI settings menu to
– "TV+AMP" if you want to listen to the
sound from the TV speaker and
receiver.
– "AMP" if you want to listen to the
sound from the receiver.
• When you connect the receiver to a video
component (projector, etc.), sound may
not be output from the receiver. In this
case, select "AMP."
• You cannot listen to the sound of a
component connected to the receiver while
a TV is selected as the input on the
receiver.
– Change the input of the receiver to
HDMI when you want to watch a
program on a component connected to
the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
• When using the Control for HDMI
function, you cannot control the connected
component using TV's remote.
– Depending on the connected component
and TV, you may need to set up the
component and TV. Refer to the
operation instructions supplied with
each component and TV.
190
GB
– Change the input of the receiver to the
HDMI input connected to the
component.
Remote commander
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 124).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Network
Cannot find the server.
• Check the following:
– Is the router is turned on?
– If there is another device between this
device and the router, check that device
is turned on.
– Are all of the cables are connected
correctly and securely?
– Is the settings to make sure that they
match the router's settings (DHCP or
fixed IP address)?
• When using a computer, check the
following:
– the built-in firewall settings for the
computer's operating system.
– the firewall settings of your security
software. To check the firewall settings
of your security software, refer to your
security software's Help section.